Features

The MCB2470 OEM board contains an NXP (formerly Philips) LPC2478 microcontroller with 512KB on-chip Flash and 96KB on-chip RAM. In addition, the MCB2470 OEM board contains the following components:

• External Flash
  128 MB NAND Flash plus 4 MB NOR Flash
• External RAM
  32 MB SDRAM
• I²C EPROM
  256 Kbit
• Crystals
  12.0000 MHz for MCU, CAN and USB
  32.768 kHz for Real-Time Clock
• 100/10M Ethernet
   National DP83848 Ethernet PHY/ transceiver
• Backup Power
  0.3F capacitor
• Joystick
  5-position
• Accelerometer
  3-axis
• Pushbuttons
  5 plus Reset

The connectors on the MCB2470 evaluation board set provide easy access to many of the LPC2478's on-chip peripherals.

• Color QVGA LCD with Touchscreen
  A 320x240 TFT LCD color VGA display module with built-in touchscreen is accessible via 18-bit RGB interface.
• Serial Port
  A standard DB9 connector is on the MCB2470 board for the LPC2478's built-in UART interfaces. Your application may use this full duplex, serial port, if required.
• CAN Port
  A 5-pin connector is on the MCB2470 board for dual CAN communications.
• 100/10M Ethernet Port
  A standard RJ45 connector on the MCB2470 base board connects to the Ethernet transceiver on the OEM board for applications requiring Ethernet communications.
• USB Ports
  Standard USB connectors for USB Device, USB-OTG, USB Host and UART via USB on the MCB2470 board for applications requiring USB communications.
• Amplifier and Speaker
  An amplifier with volume control on the MCB2470 connects the D/A output of the LPC2478 device to a speaker. You may use this amplifier to generate sound.
• Analog Voltage Control for ADC Input
  An adjustable analog voltage source is on the MCB2470 board for testing the Analog to Digital output feature of the LPC2478.
• SD/MMC Card Connector
  An SD/MMC Card connector for developing applications requiring access to SD/MMC Cards.
• ETM Trace Debug
  Provision for a Mictor-38 ETM connector for on-chip debugging via the Embedded Trace Macrocell capabilities of the LPC2478 device.
• JTAG Download and Debug
  A JTAG interface is on the MCB2470 board and, coupled with the ULINK USB-JTAG adapter, allows flash programming. The on-chip debug interface can perform real-time in-circuit emulation of the LPC2478 device. For fast PC communication, use your PC's USB port.