 MCB2400 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB2400 User's Guide
Introduction Setup
Board Setup Board Components Connecting with ULINK Setting the JTAG Clock Connecting with Serial ISP Verifying the COM Connection Connecting the QVGA Module Configuring the MCB2400 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsVerifying the COM Connection
After setting up the MCB2400 Board, use Flash Magic to verify the COM connection.
- Start Flash Magic (using Start — Programs — Flash Magic) and configure the COM Port interface as illustrated.
- Verify the COM connection using the menu command ISP — Read Device Signature....
- The Read Device Signature... displays the following window. Then close the Window.
If there are any errors, recheck your PC COM port designation and the jumper settings:
- J30 & J31 to LEFT
- J33 = ON
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
