Keil Logo

Connecting with Serial ISP

To connect the MCB2400 Evaluation Board for serial programming, you must:

  • Configure the jumpers for Flash Magic:
    • J30 & J31 to LEFT
    • J33 = ON
  • Connect power to the MCB2400 Board.
  • Connect the USB cable between the PC and the UART #0 connector on the MCB2400 Board.
  • Verify the COM Connection using Flash Magic.

Note

  • You must have installed an USB driver (USB Serial Port) on your PC in order for the USB-to-UART chip (FT232R) to function.

    FTDI Port

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.