|
|||
| Products Download Events Support Videos | |||
Technical Support
On-Line Manuals
MCB2400 User's Guide
Introduction
Setup
Board Setup
Board Components
Connecting with ULINK
Setting the JTAG Clock
Connecting with Serial ISP
Verifying the COM Connection
Connecting the QVGA Module
Configuring the MCB2400
Jumper Descriptions
Theory of Operation
Writing Programs
Example Programs
MCB2400 User's Guide
Configuring the MCB2400
The MCB2400 Evaluation Board is configured using a number of jumper settings. The MCB2400 Board ships with the following configuration:
| Jumper | State | Description |
|---|---|---|
| J13 - DBUS-EN | OFF | Signals CS2 and DYCS1 do not control DBUS_EN. |
| J19 - P2.12-NAND Ready | OFF | NAND Ready is not connected to P2.12. |
| J23 - Ethernet PHY | BOTH OFF | P0.20 and P2.11 are not connected to PD and IRQ. |
| J24 - Enable JTAG | ON | Downloading and debugging via JTAG is enabled. |
| J25 - Enable ETM | OFF | Downloading and debugging via ETM is disabled. |
| J26 - Analog Inputs | ALL ON | Both potentiometers are used for ADC inputs AD0.0 and AD0.1. |
| J27 - MCIPWR Polarity | HIGH | A high signal level powers the memory card. |
| J30, J31 - USB Serial Connect | LEFT | UART #0 connects to USB. |
| J33 - ISP Functionality | RIGHT | Disables In-System Programming via UART #0. |
| J34 - CAN Select | OFF | CAN interface is not used. |
| J36 - RS232 UART | ALL ON | Connects UART #1 to the RS232 driver and the DB-9 connector at J37. |
| J38 - WLAN UART | ALL OFF | WLAN interface is not used. |
| J41, J42, J44-46 USB Device/Host | RIGHT | USB Channel B is in Device mode. |
| J47 - MCIDAT0 | UPPER | Memory card data MCIDAT0 is connected to P0.22. |
| J48 - VBUS Sense | UPPER | VBUS sense is inverted. |
| QVGA Settings | -- | QVGA is not used. |
Note
- RS232 (J36) and WLAN (J38) jumper groups may not both be jumpered at the same time.
- CAN1 and CAN2 (J34) jumper groups may not both be jumpered at the same time.
Configuring for the ULINK USB-JTAG Adapter
The default jumper settings (above) on the MCB2400 board are pre-configured for the ULINK USB-JTAG adapter.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Buy |
|
 |
|||
