 MCB2300 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB2300 User's Guide
Introduction Setup
Board Setup Board Components Connecting with ULINK Setting the JTAG Clock Connecting With Serial ISP Verifying the COM Connection Configuring the MCB2300 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConnecting With Serial ISP
To connect the MCB2300 Evaluation Board for serial programming, you must:
- Configure the jumpers for Flash Magic:
- J9(RST) & J10(ISP) — ON
- J13(ETM) — OFF
- Connect power to the MCB2300 Board using a standard USB cable.
- Connect a 9-pin serial cable from a COM port on your PC to the COM0 connector on the MCB2300 Board.
- Verify the COM Connection using Flash Magic.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
