 MCB2300 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB2300 User's Guide
Introduction Setup
Board Setup Board Components Connecting with ULINK Setting the JTAG Clock Connecting With Serial ISP Verifying the COM Connection Configuring the MCB2300 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConnecting with ULINK
To use the MCB2300 Evaluation Board with ULINK or ULINK2, you must:
- Connect the ULINK ribbon connector to the JTAG connector of the MCB2300 board.
- Connect ULINK to the PC via a standard USB A/B cable.
- Connect power to the board using a standard USB A/B cable.
- Set the JTAG clock for your ULINK or ULINK2 adapter.
The following picture shows how to connect ULINK to the MCB2300 board.
Note
- If your application program puts the ARM device in idle or power-down mode, the Embedded ICE in the LPC2000 core (and subsequently the ULINK) stops working. Therefore, do not put the ARM device into the power saving modes during the software development cycle.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
