| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2300 User's Guide
Introduction 
Kit Contents Features Hardware Requirements Software Requirements Quick Start 
Setup Theory of Operation Writing Programs Example ProgramsHardware Requirements
To use the MCB2300 Evaluation Kit, you need:
- The MCB2300 Evaluation Board.
- An IBM-compatible PC with either of the following:
- Two unused USB ports—one to supply power to the board and one for downloading and debugging.
- An unused RS-232 COM port for Flash In-System Programming (ISP) via the Serial Interface.
To run the Keil debugger using JTAG emulation, you need:
- A ULINK USB-JTAG Adapter.
- Two USB cables.
To program the MCB2300 using the Flash Magic Utility, you need:
- A serial cable, 9-pin male to 9-pin female, no longer than 10ft/3m, wired one-to-one.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
