 MCB2140 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB2140 User's Guide
Introduction Setup
Board Setup Board Components Connecting with ULINK Connecting with Serial ISP Verifiying the COM Connection Configuring the MCB2140 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConnecting with ULINK
To use the MCB2140 Evaluation Board with ULINK, you must:
- Connect the ULINK to the PC via a standard USB cable.
- Connect ULINK to the JTAG connector of the MCB2140 board.
- Make sure that J9 - JTAG is ON.
- Connect power to the board using a standard USB cable.
The following picture shows how to connect ULINK to the MCB2140 board.
Note
- If your application program puts the ARM device in idle or power-down mode, the Embedded ICE in the LPC2000 core (and subsequently the ULINK) stops working. Therefore, do not put the ARM device into the power saving modes during the software development cycle.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
