Hardware Requirements

To use the MCB2140 Evaluation Kit, you need:

• The MCB2140 Evaluation Board.
• An IBM-compatible PC with one of the following:
• Two unused USB ports to supply power to the board, and to perform ULINK USB-JTAG downloading and debugging.
  
  
  Or
  
  
  An unused RS232 COM port for Flash In-System Programming (ISP) via Serial Interface.

To run the Keil debugger using JTAG emulation, you need:

• A ULINK USB-JTAG Adapter.
• Two USB serial cables, no longer than 10ft/3m.

To program the MCB2140 using the Flash Magic utility, you need:

• A serial cable, 9-pin male to 9-pin female, no longer than 10ft/3m, wired one-to-one.