 MCB2140 User's Guide | |
| Home Products Events Support | |
On-Line Manuals
MCB2140 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs BLINKY
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output SOUND Building SOUND Downloading SOUND Debugging SOUND VOICE Building VOICE Downloading VOICE Debugging VOICE Checking Serial Output USBHID - Human Interface Device Building USBHID Downloading USBHID Running USBHID Debugging USBHID (ULINK only) USBMEM - Mass Storage Device Building USBMEM Downloading USBMEM Running USBMEM USBAudio Building USBAudio Downloading USBAudio Running USBAudio More InformationDownloading BLINKY
When the BLINKY program is built, you may download the program to the MCB2140 using either:
- The Keil ULINK USB-JTAG Adapter, or
- The Flash Magic utility.
Note
- To debug this example, you must use the Keil ULINK USB-JTAG Adapter.
The BLINKY application starts executing when you press RESET on the MCB2140 board to verify the program downloaded.
Note
- You may enable the option Update Target before Debugging to download the BLINKY project whenever you start a Debug Session.
The downloaded program is ready for debugging.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
