 MCB2140 User's Guide | |
| Home Products Events Support | |
On-Line Manuals
MCB2140 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs BLINKY
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output SOUND Building SOUND Downloading SOUND Debugging SOUND VOICE Building VOICE Downloading VOICE Debugging VOICE Checking Serial Output USBHID - Human Interface Device Building USBHID Downloading USBHID Running USBHID Debugging USBHID (ULINK only) USBMEM - Mass Storage Device Building USBMEM Downloading USBMEM Running USBMEM USBAudio Building USBAudio Downloading USBAudio Running USBAudio More InformationDebugging BLINKY
Debug the BLINKY example program following this procedure. The debugged program is ready for the serial output check.
Use the Start/Stop Debug Session toolbar button or the µVision command Debug - Start/Stop Debug Session to connect the debugger to the Keil ULINK Adapter. The CPU stops and connects to the Embedded ICE of the LPC214x device. For details on the debugging features, refer to the µVision User's Guide.
Note
- Debugging the BLINKY program using the µVision Debugger requires a ULINK USB-JTAG adapter.
The Peripherals menu allows you to open different dialogs for Peripheral units on the LPC214x devices. You may view and/or change the state and configuration of on-chip peripherals using these dialogs. For example:
The GPIO 1 dialog reflects the status of the I/O ports.
The Phase Locked Loop (PLL) dialog shows the core clock configuration of the LPC2000 device.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
