| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2130 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting with ULINK Connecting with Serial ISP Verifying the COM Connection Configuring the MCB2130 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConfiguring the MCB2130
The MCB2130 Evaluation Board is configured using the jumpers J1 - J13. The MCB2130 Board ships with the following configuration:
| Jumper | State | Description |
|---|---|---|
| J1 - ISP | ON | Enable In-System Programming via COM0. |
| J2 - AV | ON | Connects POT1 potentiometer to AIN0 for analog input demonstration. |
| J3 - 3.3V | ON | Connects 3.3V to CPU. |
| J4 - VBAT | ON | Connects VBAT to CPU. |
| J5 - V3A | ON | Connects analog reference voltage to CPU. |
| J6 - LED | ON | Enable Port1.16 - Port1.23 LED's. |
| J7 - INT1 | ON | Enable INT1 Push Button. |
| J8 - ETM | OFF | Disable Embedded Trace |
| J9 - JTAG | ON | Enable JTAG interface |
| J10 - RST | ON | Enable Reset via COM0. |
| J11 - VREF | ON | Connects ADC VREF to 3.3V. |
| J12 | -- | There is no J12 Jumper on the board. |
| J13 - AOUT | ON | Connects AOUT via LF amplifier to the loudspeaker. |
Configuring for the ULINK USB-JTAG Adapter
The default jumper settings (above) on the MCB2130 board are pre-configured for the ULINK USB-JTAG adapter.
Configuring for Serial ISP Flash Programming
For programming the MCB2130 using the Flash Magic Utility, change the following jumper from the above default settings:
- Jumper J9 - OFF
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
