| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2103 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting with ULINK Connecting with Serial ISP Verifying the COM Connection Configuring the MCB2103 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConnecting with Serial ISP
To connect the MCB2103 Evaluation Board for serial programming, you must:
- Configure the jumpers for Flash Magic:
- J1 & J10 — ON
- J9 — OFF
- Connect power to the MCB2103 Board using a standard USB cable.
- Connect a 9-pin serial cable from a COM port on your PC to the COM0 connector on the MCB2103 Board.
- Verify the COM Connection using Flash Magic.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
