| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2103 User's Guide
Introduction 
Setup 
Board Setup Board Components Connecting with ULINK Connecting with Serial ISP Verifying the COM Connection Configuring the MCB2103 Jumper Descriptions Theory of Operation Writing Programs Example ProgramsConnecting with ULINK
To use the MCB2103 Evaluation Board with ULINK, you must:
- Connect the ULINK adapter to the PC via a standard USB cable.
- Connect ULINK to the JTAG connector of the MCB2103 board.
- Make sure that J9 - JTAG is ON.
- Connect power to the MCB2103 board using a standard USB cable.
The following picture shows how to connect ULINK to the MCB2103 board.
Note
- If your application program puts the ARM device in idle or power-down mode, the Embedded ICE in the LPC2000 core (and subsequently the ULINK) stops working. Therefore, do not put the ARM device into the power saving modes during the software development cycle.
- The MCB2103 board works with the battery installed. When the battery is removed, the battery bracket connections short together and disable the CPU. To use the board without a battery, you must separate the battery terminals with a non-conductive material.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
