| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB2103 User's Guide
Introduction 
Kit Contents Features Hardware Requirements Software Requirements Quick Start 
Setup Theory of Operation Writing Programs Example ProgramsHardware Requirements
To use the MCB2103 Evaluation Kit, you need:
- The MCB2103 Evaluation Board.
- An IBM-compatible PC with one of the following:
- Two unused USB ports to supply power to the board and to perform ULINK USB-JTAG downloading and debugging
Or
- An unused RS232 COM port for In-System Flash Programming (ISP) via Serial Interface.
To run the Keil debugger using JTAG emulation, you need:
- A ULINK USB-JTAG Adapter.
- Two USB serial cables, no longer than 10ft/3m.
To program the MCB2103 using the Flash Magic utility, you need:
- A serial cable, 9-pin male to 9-pin female, no longer than 10ft/3m, wired one-to-one.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
