Hardware Requirements

To use the MCB2100 Evaluation Kit, you need:

• The MCB2100 Evaluation Board.
• An IBM-compatible PC with one of the following:
• • An available USB port for ULINK USB-JTAG downloading and debugging.

  • Or

  • An available RS232 COM port for Flash In-System Programming (ISP) using a Serial Interface.
• A 6V - 9V DC, 150mA power supply.

To run the Keil debugger using JTAG emulation, you need:

• A ULINK USB-JTAG Adapter.
• A USB serial cable, no longer than 10ft/3m.

To program the MCB2100 using the Flash Magic utility. you need:

• A serial cable, 9-pin male to 9-pin female, no longer than 10ft/3m, wired one-to-one.