Connecting with ULINK

To use the MCB2100 Evaluation Board with ULINK, you must:

• Connect the ULINK to the PC via a standard USB cable.
• Connect ULINK to the JTAG connector of the MCB2100 board.
• Make sure that J9 - JTAG is ON.
• Connect power to the board using a 6V - 9V DC, 150mA power supply.

The following picture shows how to connect ULINK to the MCB2100 board.

Note

• If your application program puts the ARM device in idle or power-down mode, the Embedded ICE in the LPC2000 core (and the ULINK) stops working. Therefore, do not put the ARM device into power saving modes during the software development cycle.