 MCB2100 User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
MCB2100 User's Guide
Introduction Setup Theory of Operation Writing Programs Example Programs BLINKY
Building BLINKY Downloading BLINKY Debugging BLINKY Checking Serial Output BLINKYCAN Building BLINKYCAN Downloading BLINKYCAN Debugging BLINKYCAN Checking Serial Output BLINKY IRQ Debug I/ODebugging BLINKYCAN
Debug the BLINKYCAN example program following this procedure. The debugged program is ready for the serial output check.
Use the Start/Stop Debug Session toolbar button or the µVision command Debug - Start/Stop Debug Session to connect the debugger to the Keil ULINK Adapter. The CPU stops and connects to the Embedded ICE of the LPC21xx device. For details on the debugging features, refer to the µVision User's Guide.
Note
- Debugging the BLINKYCAN program using the µVision Debugger requires a ULINK USB-JTAG adapter.
The Peripherals menu allows you to open different dialogs for Peripheral units on the LPC21xx devices. You may view and/or change the state and configuration of on-chip peripherals using these dialogs. For example:
The GPIO 1 dialog reflects the status of the I/O ports.
The Phase Locked Loop (PLL) dialog shows the core clock configuration of the LPC2000 device.
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
