| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB1700 User's Guide
Introduction Setup 
Theory of Operation 
Block Diagram Schematics Technical Data Prototyping Area Microcontroller Power Supply JTAG Interface ETM Interface LCD Panel LEDs Push Buttons Joystick Potentiometer Speaker Serial Ports CAN Interface USB Interface Ethernet Interface MicroSD Connector Writing Programs Example ProgramsLEDs
The LEDs on the MCB1700 board are:
- The POWER LED indicates that power is present on the board.
- The 8 Port LEDs marked P1.28, P1.29, P1.31 and P2.2 - P2.6 connect to their respective port pins when jumper LED is installed. These LEDs are useful for indicating program status while testing your applications. Removing Jumper LED disables the LED driver chip (IC9).
- The 100M LED indicates a 100Mbit Ethernet LAN connection.
- The ORANGE LED (right/lower) on the Ethernet connector indicates LAN traffic is present.
- The GREEN LED (left/upper) on the Ethernet connector indicates a good link connection to the LAN.
- The USC LED indicates a USB soft connect from P2.9.
- The UGL LED indicates a good USB link.
- The SD LED indicates that an SD card is detected.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
