Keil Logo

Connecting with ULINK

To use the MCB1700 Evaluation Board with ULINK or ULINK2, you must:

  • Connect the ULINK ribbon connector to the JTAG connector of the MCB1700 board.
  • Connect ULINK to the PC via a standard USB A/B cable.
  • Connect power to the board using a standard USB A/B cable.
  • Set the JTAG clock for your ULINK or ULINK2 adapter.

The following picture shows how to connect ULINK to the MCB1700 board.

MCB1700 Board Connected to the ULINK2 JTAG Adapter

Note

  • If your application program puts the ARM device in idle or power-down mode, the CoreSight debug port in the LPC1700 core (and subsequently the ULINK) stops working. Therefore, do not put the Cortex-M3 device into the power saving modes during the software development cycle.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.