Configuring the MCB1700

The MCB1700 Evaluation Board is configured using the jumpers below. The MCB1700 Board ships with the following configuration:

Jumper	State	Description
E/C	ENET	Connects P2.8 for CAN2 or Ethernet use.
D-	HOST	Configures USB Line D- to HOST mode.
D+	HOST	Configures USB Line D+ to HOST mode.
SPK	ON	Connects AOUT (P0.26) via LF amplifier to the loudspeaker.
VBAT	ON	Connects the on-board battery to the VBAT pin.
VDDIO	ON	Supplies 3.3 VDC to the VDDIO pin.
VDDREG	ON	Supplies 3.3 VDC to the VDDREG pin.
VBUS	ON	Supplies 5 VDC power to the board from the USB-B connector VBUS pin.
UMODE	ON	Allows soft-connect of the USB device by issuing a software restart via P2.9
AD0.2	ON	Connects POT1 potentiometer to AD0.2 for analog input.
INT0	ON	Enables the INT0 Push Button.
RST	ON	Enables Reset via COM0.
ISP	ON	Disables In-System Programming via COM0.
LED	ON	Enables the P1.28, P1.29, P1.31, P2.2 - P2.6 LEDs.
E/U	ON	Connects P2.9 to pin 1 of the UMODE jumper block.

Configuring for the ULINK USB-JTAG Adapter

The default jumper settings (above) on the MCB1700 board are pre-configured for the ULINK USB-JTAG adapter.