| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
MCB1000 User's Guide
Introduction Setup 
Theory of Operation 
Block Diagram Schematics Technical Data Prototyping Access Microcontroller Power Supply Cortex Debug Interface LEDs Push Buttons Serial Port CAN Interface USB Interface Writing Programs Example ProgramsPush Buttons
The four push buttons on the MCB1xxx boards are:
- The RESET push button (S1) grounds the RESET pin which resets the microcontroller.
- The ISP push button (S2) grounds PIO0.1 pin on the microcontroller. When jumper J7 is removed, holding down this button during a reset enables ISP flashing via the CAN interface.
- The S3 and S4 push buttons are for general purpose use.
- For the MCB11xx, MCB11Cxx and MCB13xx boards, pushing buttons S3 or S4 grounds pins PIO1_4 or PIO1_5 resectively.
- For the MCB11U10 board, pushing buttons S3 or S4 grounds pins PIO0_16 or PIO0_17 resectively.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
