| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
J-Link/J-Trace User's Guide
Introduction CoreSight Technology 
Install J-Link/J-Trace Driver Configure µVision Use J-Link/J-Trace 
Configure Cortex-M Devices for Tracing Atmel AT91SAM3 Devices Enable Serial Wire Trace Luminary LM3Sx Devices Enable Serial Wire Trace NXP LPC17xx Devices Enable 4-Pin Trace (ETM) Enable Serial Wire Trace STMicroelectronics STM32F10xxx Devices Enable 4-Pin Trace (ETM) Enable Serial Wire Trace Toshiba TMPM330 Devices Enable 4-Pin Trace (ETM) Enable Serial Wire Trace Toshiba TMPM360 Devices Enable 4-Pin Trace (ETM) Enable Serial Wire Trace µVision WindowsConfigure Cortex-M Devices for Tracing
The examples below explain how to configure µVision, the J-Link anadpter, and the target system for tracing:
- Atmel AT91SAM3 Devices
- Luminary LM3S Devices
- NXP LPC17xx Devices
- STMicroelectronics STM32F10xxx Devices
- Toshiba TMPM330 Devices
Note
- To control the trace output, refer to Trace Settings.
- The device's data sheet or user manual provides information for the configuration.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
