| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
EPM900 User's Guide
Introduction Setup Theory of Operation 
Using the EPM900 
LPC900 Development Studio Application Notes Emulator Mode Connecting to the Target Configuring the Hardware Configuring the Project Configuring the Debugger Programmer Mode Connecting the Device Configuring the EPM900 Configuring the µVision Flash Utility Downloading the Program Programming HEX Files Example ProgramsConfiguring the Hardware
The EPM900 is configured by several jumpers (J1, J2, and XTAL).
Emulation Mode
 Set J1 and J2 to Emu to select emulation mode. In this mode the EPM900 operates as an emulator. Power (3.3 Volts) from the EPM900 is supplied to the emulated device's VDD pin. |
Emulation Mode Without Target Power
 Set J1 to Emu to select emulation mode and remove J2 to disconnect the target power supply from the EPM900 power supply. When J2 is removed, the VDD pin of the device under emulation is not supplied with 3.3V power from the EPM900. |
Clock Source
 The Philips LPC900 devices support several clock sources. The XTAL jumpers select whether the clock is internal (int.) or external (ext.). If an external clock is used you must populate Q1 (user-XTAL) on the EPM900 board. |
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
