 RealView Assembler User's Guide | |
| Home Products Events Support | |
Technical Support
On-Line Manuals
RealView Assembler User's Guide
Preface Introduction Writing ARM Assembly Language Assembler Reference Command syntax
Obtaining a list of available options Specifying command‑line options with an environm AAPCS Floating‑point model Memory access attributes Pre‑executing a SET directive Splitting long LDMs and STMs Listing output to a file Project template options Controlling the output of diagnostic messages Controlling exception table generation Format of source lines Predefined register and coprocessor names Predeclared register names Predeclared extension register names Predeclared coprocessor names Built‑in variables and constants Symbols Symbol naming rules Variables Numeric constants Assembly time substitution of variables Labels Local labels Expressions, literals, and operators String expressions String literals Numeric expressions Numeric literals Floating‑point literals Register‑relative and program‑relative express Logical expressions Logical literals Operator precedence Unary operators Binary operators Diagnostic messages Interlocks IT block generation Thumb branch target alignment Using the C preprocessor ARM and Thumb Instructions Directives ReferenceListing output to a file
  | |||
  |  | ||
| |||
| Home > Assembler Reference > Command syntax > Listing output to a file | |||
Use the following option to list output to a file:
‑‑list file
This instructs the assembler to output a detailed listing of the assembly language produced by the assembler to file
If ‑ is given as filestdout.
If no file‑‑list= to send the output to inputfile.lst
Note
You can use ‑‑list without a filename to send the output to inputfile.lst‑‑list= instead.
Use the following command‑line options to control the behavior of ‑‑list:
‑‑no_terseTurns the
terseflag off. When this option is on, lines skipped due to conditional assembly do not appear in the listing. If theterseoption is off, these lines do appear in the listing. The default is on.‑‑widthSets the listing page width. The default is 79 characters.
‑‑lengthSets the listing page length. Length zero means an unpaged listing. The default is 66 lines.
‑‑xrefInstructs the assembler to list cross‑referencing information on symbols, including where they were defined and where they were used, both inside and outside macros. The default is off.
| Copyright © 2007 ARM Limited. All rights reserved. | ARM DUI 0379A |
 PDF version | |
| Home > Assembler Reference > Command syntax > Listing output to a file | |
| |
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
