ENDIF Assembler Statement

ENDIF

The ENDIF statement terminates an IF-ELSE-ENDIF statement construct. When the assembler encounters an ENDIF statement, it concludes processing the IF block and resumes assembly at the point of the corresponding IF statement. Since IF blocks may be nested, this may involve continuing in another IF block. The ENDIF statement must be preceded by an IF, ELSEIF, or ELSE block.

Note

• Do not confuse the ENDIF statement with the $ENDIF directive. They are not equivalent and they may not be used with the same symbols.

ELSE, ELSEIF, EQU, IF, LIT, SET

IF (SWITCH = 1)
.
.
.
ELSEIF (SWITCH = 2)
.
.
.
ELSE
.
.
.
ENDIF