Keil Logo

µVISION DEBUGGER: Restrictions on usage of LPC-Link2


Information in this knowledgebase article applies to:

  • NXP LPC-Link2

SYMPTOM

When I program a part using NXP's LPC-Link2 debug adapter, I see a message with several restrictions pop up on the output window, such as:

The firmware is for use with evaluation boards only. It is not for use with
custom hardware.

The firmware may only be used for development and/or evaluation purposes. It
may not be used for production purposes.

CAUSE

These messages come from the Segger J-Link firmware on the LPC-Link2.

RESOLUTION

Please reconfigure your LPC-Link2 to run as a CMSIS-DAP device. This mode has no such restrictions.

MORE INFORMATION

Last Reviewed: Thursday, September 22, 2016


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.