Keil Logo

LICENSE: can't select device when using Infineon vendor license


Information in this knowledgebase article applies to:

  • MDK-ARM 5

SYMPTOM

I have installed MDK-ARM 5.15 and registered it with an Infineon-specific M0/M0+ license. But even after installing the current Infineon::XMC1000_DFP with the Pack Installer, I can't select a device from the "Software Packs" device list in an existing project or when creating a new project. The device selection list is empty. What is the problem?

CAUSE

There is a bug in µVision that prevents the vendor-specific devices from appearing in the "Software Packs" device list.

RESOLUTION

To make the devices selectable, first close µVision. Then add the line (or modify the corresponding existing line)

LEGACY_CM=1

in the [UV2] section in TOOLS.INI. To do this, open _KEIL_INSTALLATION_PATH_\TOOLS.INI with a text editor and make the required modification. Save the file and then start µVision again to make your device selection.

STATUS

This problem was fixed in MDK-ARM 5.16.

MORE INFORMATION

  • Refer to Device in the µVision User's Guide.

Last Reviewed: Wednesday, August 26, 2015


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.