Keil Logo

ULINK: Using LPCXpresso boards with ULINK2


Information in this knowledgebase article applies to:

  • ULINK2 Debug Adapters

QUESTION

I'm trying to use my ULINK2 adapter with an LPCXpresso LPC800 board, but when I try to connect to the target, I get:

SWD Communication Failure

How can I get ULINK2 to work with the LPCXpresso LPC800 board?

ANSWER

The LPCXpresso LPC800 board does not supply VCC to pin 1 on the 10-pin J5 connector. To use ULINK2 with this board, you must make sure the jumper inside the ULINK2 adapter is in the 3,3V position.

MORE INFORMATION

SEE ALSO

  • Refer to Jumpers in the ULINK2 User's Guide.

Last Reviewed: Friday, February 8, 2013


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.