Keil Logo

µVISION DEBUGGER: Setting Conditional Breakpoints


Information in this knowledgebase article applies to:

  • µVision Version 4.00 and later

QUESTION

After I set a conditional breakpoint in the debugger, when I try to run, I get the message:

Target Device does not support conditional breakpoints.

But my device should support this. What could be wrong?

ANSWER

You will get this message if you do not set the Read and Write checkboxes when defining your breakpoint. To fix this:

  1. Start the Debugger.
  2. Use Ctrl+B to open the Breakpoints dialog.
  3. Double-click your conditional breakpoint to select it.
  4. Check the Read and Write checkboxes.
  5. Click Define. This builds a another breakpoint with your changes.
  6. Select the original breakpoint and then click Kill Selected to remove the original breakpoint.
  7. Then click Close.

MORE INFORMATION

SEE ALSO

Last Reviewed: Thursday, August 16, 2012


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.