Keil Logo

ULINK: "Invalid ROM Table" on STM32 Device


Information in this knowledgebase article applies to:

  • ULINK2, ULINK-ME and ULINKPro

PROBLEM

When trying to download to my STM32 device, using ULINK2, ULINK-ME or ULINKPro, I get the following message:

Invalid ROM Table

The ULINK-ME/ULINK2 and ULINKPro adapters have worked with this board in the past. How can get downloading to work again?

SOLUTION

For ULINK2, ULINK-ME and ULINKPro debug adapters, make sure the Connect and Reset Options in Options For Target — Debug — Settings are set as follows:

  • The Connect: option must be set to under Reset
  • The Reset: option must be set to HW RESET

After saving these options, cycle power on the target device, then try the download again. Your application should download as before.

MORE INFORMATION

  • Refer to Debug in the ULINK2 User's Guide.

SEE ALSO

FORUM THREADS

The following Discussion Forum threads may provide information related to this topic.

Last Reviewed: Thursday, January 26, 2012


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.