Keil Logo

ULINK: CANNOT DEBUG LPC2378 OR LPC2368 DEVICE


Information in this article applies to:

  • ULINK2 USB-JTAG Adapter
  • NXP LPC2368 or LPC2378 A-Step device

QUESTION

I am using the Ethernet controller on the LPC23xx devices (A-Step version). After initalization of the Ethernet software I am getting the following error from ULINK:

ULINK - ARM Error:
Could not stop ARM device!
Please check the JTAG cable.

What can be wrong?

ANSWER

The A-Step devices require a slightly different Ethernet initialization (explained also in the NXP errata sheet). It is required that you change the initalization code as explained in the Knowledgebase Article MCB2300: ETHERNET INTERFACE FAILS ON A-STEP DEVICES

MORE INFORMATION

  • NXP LPC2364/66/68/78 User's Manual
  • NXP LPC2364/66/68/78 Errata Sheet

SEE ALSO

Last Reviewed: Wednesday, September 5, 2007


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.