Keil Logo

MCB2300: USB EXAMPLES DO NOT WORK


Information in this article applies to:

  • MCB2300 Evaluation Boards

QUESTION

I have downloaded the following USB example projects:

However none of these examples seems to work. I am using the MCB2370 Board. Are these examples only for the MCB2360 Board?

ANSWER

The examples work on both board variants MCB2360 and MCB2370. The problem might be the jumper settings. When the jumper J13 - ETM is set the jumper J5 - UMODE needs to be in position towards the prototyping area.

MORE INFORMATION

Last Reviewed: Thursday, March 1, 2007


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.