 Technical Support | |
| Home Products Events Support | |
Technical Support
Support Resources
- Support Knowledgebase
- Product Manuals
- Application Notes
- File Download Area
- Product Updates
- Discussion Forum
- Books
Product Information
ULINK: FLASH MUST START AT 0XC00000
Information in this article applies to:
- ULINK USB-JTAG Adapter
- ULINK2 USB-JTAG Adapter
QUESTION
When I try to download my application into the flash of my Infineon XC16x microcontroller I get the following error message:
The Start Address of the On-chip Flash must be 0xC00000
Why do I get this error?
ANSWER
You have selected an XC16x On-chip Flash programming algorithm in the Infineon XC16x Target Driver Setup dialog and must have set its default starting address to 0xC00000.
The starting address of a flash device must be the physical starting address even if your application code starts at a higher address. This address is used as a base address to access the flash programming registers.
MORE INFORMATION
- Refer to Flash Download Configuration in the ULINK User's Guide.
Last Reviewed: Sunday, January 28, 2007
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
