 Technical Support | |
| Home Products Events Support | |
Technical Support
Support Resources
- Support Knowledgebase
- Product Manuals
- Application Notes
- File Download Area
- Product Updates
- Discussion Forum
- Books
Product Information
EPM900: PORT PINS P1.2 AND P1.3 CANNOT BE RECONFIGURED
Information in this article applies to:
- EPM900 LPC900 Emulator/Programmer
QUESTION
The GPIO pins P1.2/P1.3 on the EPM900 Emulator cannot be configured for push-pull or quasi I/O mode. Is there a software update for this?
ANSWER
This problem is present in LPC900 devices (P89LPC901/907/912/914/9102/9103/9107) that do not provide an I2C interface.
Unfortunately, this is a shortcoming of the P89LPC93x bondout device that is used on the EPM900 Emulator/Programmer.
The P89LPC93x bondout chip has an I2C interface on P1.2 and P1.3 and, as such, the pins are configured as open-drain outputs. The mode on these I/O pins is fixed on the bondout device and cannot be changed.
As a workaround you may use external pull-up resistors on this I/O pins. This workaround will show that the ports are working, but does not provide the same current drive characteristics as on the production device.
Last Reviewed: Friday, January 12, 2007
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
