 Technical Support | |
| Home Products Events Support | |
Technical Support
Support Resources
- Support Knowledgebase
- Product Manuals
- Application Notes
- File Download Area
- Product Updates
- Discussion Forum
- Books
Product Information
ULINK: ADUC7020 MAPS ADCBUSY TO JTAG TRST SIGNAL
Information in this article applies to:
- ULINK USB-JTAG Adapter
- ULINK2 USB-JTAG Adapter
QUESTION
I have used the Analog Devices ADuC7020 Development Kit together with Keil µVision3 and the Keil CARM Compiler. Since I have configured the chip to use the ADCBUSY signal on IO Pin P0.3 the ULINK is dead. I know that this pin is shared with the TRST signal that is used by the JTAG interface, but I would like to know if there is an alternative solution to this problem.
ANSWER
You are correct. The problem lies with the fact that P0.3 is used for both TRST and ADCBUSY. You can just re-configure the I/O pins so that the ADCBUSY uses the P0.5 as output. In this way, there is no collision.
MORE INFORMATION
- Refer to Analog Devices ADuC702x in the ULINK User's Guide.
Last Reviewed: Sunday, January 28, 2007
| Contact Site Map Press Privacy | Copyright © 2008 Keil™, An ARM® Company. All rights reserved. |
