EPM900: EPM900 NOT RESPONDING AFTER ISP PROGRAMMING

Information in this article applies to:

• EPM900 LPC Emulator

QUESTION

I have been using my EPM900 emulation board In-System Programming ability. Recently, the board has stopped responding. What is wrong?

ANSWER

You should contact Philips to get programmed LPC935 bond out chips. The design of the LPC932 bond out chip makes it possible to damage the chip during ISP programming. The LPC935 bond out chips are protected in a way that prevents them from being damaged from ISP programming.

MORE INFORMATION

• Refer to Supported Devices in the EPM900 User's Guide.

SEE ALSO

• EPM900: EMULATION AND PROGRAMMING ADAPTERS
• EPM900: PROGRAMMER REPORTS THIS IS NOT A LPC9XX DEVICE
• EPM900: IAP, ISP SUPPORT FOR EPM900

****************************************************************************

Last Reviewed: Thursday, November 30, 2006