MCB900: Documentation for MCB900 V4 is Missing

Information in this article applies to:

• MCB900 Evaluation Boards v4

QUESTION

The Documentation shipped with my MCB900 does not match the board that I have. Where can I find the correct jumper settings and schematics?

ANSWER

The schematics are included on the CARM V1.2a (and later) updates.

Jumpers must be set as follows:

• for FlashMagic: RESET - ON; RUN - OFF
• for µVision/ISD51: RESET - ON; RUN - OFF
• for User Run: RESET - OFF; RUN - ON

MORE INFORMATION

• Refer to Schematics in the MCB900 User's Guide.

Last Reviewed: Thursday, February 25, 2021