MCB900: MISSING PARTS (J2,R7,R8) ON THE BOARD

Information in this article applies to:

• MCB900 Evaluation Boards

QUESTION

I have the MCB900 board Version 2, but the parts J2, R7, and R8 are empty. Do I need to add these parts before using the board? Why are these parts missing?

ANSWER

The MCB900 board uses the P89LPC932 E-step or F-step devices that have an enhanced flash ISP loader. This loader does not require extra jumpers or extra off-chip resistors. By omitting the jumper J2 and the resistors R7 and R8, you have an extra I/O pin available.

MORE INFORMATION

• Refer to Schematics in the MCB900 User's Guide.
• Philips P89LPC932 User's Manual

SEE ALSO

• MCB900: MISSING PARTS (Q1,C8,C9) ON THE BAORD
• MCB900: PROBLEMS WITH IN-SYSTEM PROGRAMMING USING FLASHMAGIC

Last Reviewed: Thursday, November 30, 2006