Keil Logo


Information in this article applies to:

  • ULINK USB-JTAG Adapter
  • ULINK2 USB-JTAG Adapter


Is there a specific power-up sequence that I need to consider when connecting the ULINK to an XC16x device?

Does it matter in what order I power on the ULINK and the target system?


There is no power-up sequence requirement for connecting a ULINK to an XC16x device. As long as ULINK is not powered, the XC16x device will be held in the RESET state. This is not typically a problem since connecting an OCDS debugger usually indicates that you want to debug your system.


Last Reviewed: Sunday, January 28, 2007

Did this article provide the answer you needed?
Not Sure
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.