Keil Logo

µVISION DEBUGGER: DS80C400 CONTIGUOUS MODE DOES NOT WORK


Information in this article applies to:

  • C51 Version 7.03

QUESTION

I have a program that works perfectly with Dallas DS390 in contiguous mode. When I change the target chip to Dallas DS80C400, keeping the same settings, the program should still work since DS390 and DS400 are comparable, but the contiguous mode is not working properly over DS400. What could be wrong?

ANSWER

This is a device database problem that has been resolved in C51 Version 7.04. You may download the latest updates from the Keil Website.

SEE ALSO

Last Reviewed: Thursday, August 4, 2005


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.