This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Timestamp Error! in Event Viewer

Using µVision V5.24.2.0 with ULinkPro V1.58 on target LPC1343 (Cortex-M3, 72 MHz) via SW.
Event Viewer always stops with message "Timestap Error!".
Tried all Timestamp Prescaler (1, 4, 16, 64) no success.
Tried different SW Max. Clocks (1, 10, 50 MHz) , no success.
Tried SWJ checkbox on and off, no success.
Tried "Clear" in Event Viewer window. After about 5 secs Timestamp Error appears again.

Is there any Suggestion for Debug and/or UlinkPro Settings which should be used?

Bets Regards Juergn.