Hello, I try micro Keil v4 for debugging of lpc2148 nut when I debug program it shows no u link Debugger found It Supports 32k Limits. my Controller is LPC2148 64-bit controller I also install Micro Keil v5 and also in that I install ARM7 legacy but there is no any controller shown in keil v5. What can I do for Support 64-bit Ulink debugger which Run My program. Please Any one can help me to solve this problem??
Do you *actually* have a ULINK debugger? If you don't have one it will be very hard for the software to *find* it.
The uV software should have installed the drive during product installation. There should be a ULINK installer under one of the directories you installed the product. Like keil arm ulink
"my Controller is LPC2148 64-bit controller"
Now, I'm curious. Exactly where can I buy 64-bit editions of NXP LPC2148? I have only managed to find 32-bit variants of LPC2148. Might I be lucky that there are even multi-core variants of LPC2148?
Try downgrading the firmware of the Ulink2 as described here:
http://www.keil.com/support/docs/3632.htm
The newer Ulinks default to CMSIS-DAP mode that is not compatible with the LPC2148.