This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Optimization issues

Hi all,

I am working with Infineon XC866 controller.
I am measuring the number of cycles consumed by the keil built in libraries.

To optimize the speed i am selecting Favour speed in the project settings.I have selected the level of optimization as 9.I could not find any improvement in the cycles.

Further there is no improvement in the code size if i give Favour size in the project settings.

Whether anyother settings should be taken care to generate an optimised code by the compiler?

Please help me out

Thanks in advance
Chris