This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ARM TOOLS QUIRKINESS

I'm evaluating the Demo version of the ARM7 tools from Keil and notice a lot of unusual quirkiness when dealing with the Flash erase procedure called out in Philips' IAP section. Many times I've had to power down the eval MCB2100 board, constantly re-enter Debug mode, do the hokey-pokey, etc. to re-establish the code and get it to run.

On one occasion, I had put into the Memory Window address 0xFFFFF030 (or any other address from the Vectored Interrupt Controller (VIC)) and my target just froze up.

Anyone else experiencing strange stuff with this eval board and ARM7 tools?
Thanks.