This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Initialization of values with Port 0

Hi,

I am working on a university project that uses the Infineon C167SR-LM micro, and am having some difficulty with the debugger in simulation mode.

Is there a way to either:

(1) force the debugger to use the reset values from Port 0 (to set the SALSET and CSSEL lines, assuming EA is set low), or

(2) set the SALSEL and CSSEL lines manually?


I'd appreciated any assistance in this matter.

Thanks!
Darryl Millette