MCBSTR7 Eval board does not response to STR_IAP code

Details	Message
Read-Only Author JIMMY Sayavong Posted 27-May-2006 15:25 GMT Toolset ARM	MCBSTR7 Eval board does not response to STR_IAP code JIMMY Sayavong I tried to program the flash on the MCBSTR7 eval board (HITEX STR7) using the STR_IAP code (via UART) which I downloaded from KEIL website. The code was compiled property with a minor warning but after I loaded into the flash assuming that it went to IAP section of the chip. After the board was reboot, and the HYPER terminal was running (according to instrucion on AN2078 from STmicro), the board did not response to "sending file command" from terminal program --- eventully timed-out Does anybody in this forum sucessefully has used the STR_IAP ver2.0 with the MCBSTR7 eval board? please share you experience. Thanks in advance

Read-Only Author Reinhard Keil Posted 29-May-2006 14:34 GMT Toolset ARM	RE: MCBSTR7 Eval board does not response to STR_IAP code Reinhard Keil Hello Jimmy, were did you downlaod the example? Can you please give us the link? To recover the STR7 Board please proceed as explained in: http://www.keil.com/support/docs/3001.htm

Read-Only Author Jimmy Sayavong Posted 30-May-2006 00:24 GMT Toolset ARM	RE: MCBSTR7 Eval board does not response to STR_IAP code Jimmy Sayavong Here is the link to the s/w I downloaded. http://www.keil.com/download/docs/313.asp What you were talking about was using JTAG Interface !!! Completely differend topic. JIMMY