*** error 57: illegal address (0x08000000)

I write a simple code that just setup clock and initial conditions for STM32F103RBT6, and program it on my board via ULINK2 successfully.

But while I'm going to debug mode, I see this error :

*** error 57: illegal address (0x08000000)
Also, I can not set a breakpoint on my program, but disassembly section works for while then trapped in a loop.

note that I have many other programs that I did programming on my board successfully and debugging via this ULINK2, but this simple one take all of my time!

I try all of debug settings in a various manner, even I use CUBEMX to create project again. even test it on both JTAG and SWD too, but no success. I'm hanging!

There is some pic form my settings:

i.stack.imgur.com/E1vKB.png
i.stack.imgur.com/MjXz5.png
i.stack.imgur.com/YmGrv.png
i.stack.imgur.com/V1kKc.png
i.stack.imgur.com/qfjBB.png
i.stack.imgur.com/rBZij.png