hi, i am using MCBSTM3200 board to send values to serial monitor using UART4. i am getting values through UART4 on serial monitor . For example if i transmit 123 it is coming as 1312 ,121 skipping some of the digits .could you please tell what should be the reasons for this and i would also like to know about jumper settings for UART4 on MCBSTM3200.
Thanks in advance, krishna
So what "serial monitor" are you using?
If you are seeing all good characters - ie, no junk - that probably means your board rates and wiring are OK.
So that leaves bugs in your code.
So what debugging have you done ?
www.avrfreaks.net/.../2418156
"i would also like to know about jumper settings for UART4 on MCBSTM3200"
That will be in the board documentation