This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

connect mcb 2300 to CRO

hey, I am using mcb2300 for pulse generation and I am not able to create circuit to check the pulse output. so, please tell me how to connect a CRO to mcb2300 board.
help me.... please

  • Attach the scope probe's ground to one on the board, and then attach the probe to the signal you wish to measure. Perhaps there is a manual or schematic for the board you could utilize to find the pin/signal in question. If necessary solder some test points, or hoops, to the board to allow the probe to easily clamp to it.

    Please use/find some common sense...

  • sir, thanks for your advise,i know these steps but the problem is when i download the programme in MCB2300 and compile it,all the values in output is different.when I simulate my programme in system everything was right. but I am still not able to download and run my programme in my board.